Comments on: Calphalon 24-Inch Half Round Wall Rack

By: Dolphin

Dolphin — Wed, 05 May 2010 04:04:22 +0000

This device is very useful, convenient, good room for protection. It is very difficult because the plant is almost impossible to withdraw bolt and tie. Moreover, the gap is less than a preset distance from the nail more often, I had new holes drilled. You need patience and prospects for small spaces and many different types wrences. In sumamry is solid, but the design is not. Just a few holes in the distance between the rear bar Greter will help a lot. Calphalon can do better with very little effort. The rating reflects the system: No stars! I hate it during the installation process, and now I find it afterwards.

By: Tom Tinker

Tom Tinker — Wed, 05 May 2010 02:37:05 +0000

I just installed another one of them. I love the material (about 1 / 4 black anodized aluminum “thick 2″ wide), solid feel, the general design and construction of his way. Some of the comments previously complained that hole does not seem to be 16 “except to the stud needs. In fact, even if you do not try to bolt between the centers of the rack. If you have a left or right corner of Zai Lo column, a second set of holes is 16 “walk this line should be studied. Installation instructions carefully, hear! – Instructions say I need 7 / 16 “wrench nut of the nut, but proved to be 10 mm. (I’m a 1 / 4″ drive ratchet socket options, because sometimes there are not many barriers between rooms, with a wrench.) – Indicates that there are eight, including bolts, of equal length. In fact, the short length of 6 and 2. The longer the walk, the middle of their participation in the three metal thickness. – Step 2 of the note describes how to join the long flat part of the curved bar. If you follow the instructions exactly, a 50% chance when you step 7 instead what Du not like you go back to Step 2, take Danwei bar closed and open it to the final end. I strongly recommend that all screws first and only hand tight, but neglected step said to the rack on the wall. Instead of parts of the rest, to ensure that they really fit. Once they do, you are very lucky to go in the last two again (to obtain the required), turn the screw breaks, extra frame on the wall, and complete the installation.

By: TIna

TIna — Wed, 05 May 2010 01:09:54 +0000

We asked our building administrators to install our pot rack, so I can not comment on the installation. But the quality is good, it can be integrated into a very small room (our kitchen pan / pot is small – barely big enough for one person). We hang on the wall, so pots and pans that are lower than us, we must go below. I highly recommend this product.

By: Pamela Roza

Pamela Roza — Tue, 04 May 2010 22:42:52 +0000

I have a pot about 10 years this aircraft has. I like it. This is incredibly strong, as is well installed. I have some time, I can not be installed because the wall will not unbearable weight of the rack to impede, if you’re stuck in an apartment this basin.

By: Kitty Gould

Kitty Gould — Tue, 04 May 2010 20:28:33 +0000

I love all my pots and pans is more convenient. As for installation, we live in a very old house. No 16-inch beyond the stud. We have solved by measuring between the bolts and cut into 2 “x 4″ (stain, paint or the length of the distance problem). We have 2×4 wall with a long screw drill and made pot rack for 2×4. It works. . . And I love the pot rack connivence. No more bending and pull all my pots in one, and then later use, again pulling all the pot they had.